EasyManuals Logo

Sea-doo 2012 Sea Doo RXT series User Manual

Sea-doo 2012 Sea Doo RXT series
192 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #87 background imageLoading...
Page #87 background image
SUSPENSION
Dock Mode AUTO
In DOCK MODE AUTO, the suspen-
sion lowers to DOCK mode height to
lower the center of gravity when cer-
tain conditions are met.
When the engine is shut down after
normal operation of the watercraft
(always).
If O.T.A.S. is activated.
If the operator releases the throt-
tletoidleRPMforapproximately
10 seconds, after operating at or
above a calibrated RPM for a given
period of time.
NOTE: When the suspension moves
down to dock mode height, a DOCK
MODE ON message will scroll across
in the multifunction display.
Dock Mode OFF
If the suspension is set to DOCK
MODE OFF, the suspension will not
lower itself to DOCK mode height
when the throttle is released to idle
for more than ten seconds. However,
it will lower itself automatically when
the engine is shut off, or when O.T.A.S.
is activated during a full LH or RH brak-
ing turn.
If the suspension is in the up position
with the watercraft powered up and
the iS DOWN button is double clicked,
the suspension will lower itself to
DOCK mode height even if the sus-
pensionissettoDOCKMODEOFF.
If the suspension is in the down posi-
tion (dockmode height)with thewater-
craft powered up and the iS UP button
is double clicked, the suspension wi
ll
move up to the factory preset height.
WARNING
When performing certain maneu-
vers at low speed or when dock-
ing, the watercraft's propensity to
overturn can increase. The more
riders (or weight) on the moving
deck, the more unstable the water-
craft may become.
NOTE: DOCK MODE AUTO is always
active when using a rental or a learning
key.
Selecting DOCK MODE AUTO or
DOCK MODE OFF
Selecting DOCK MODE AUTO or
DOCK MODE OFF is only available
when the engine is not running.
To change the DOCK mode of opera-
tion, carry out the following steps.
1. Press the START/STOP button to
power up the information center.
2. Install the tether cord on the engine
cut-off switch.
3. Press the MODE button repeatedly
until SETTINGS is displayed in the
Information Center.
smo2009-002-114_y
FUNCTION SELECTED - SETTINGS
4. Press the SET button to display
DOCK MODE.
smo2009-002-114_bb
FIRST MODE AVAILABLE - DOCK MODE
_______________
85

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Sea-doo 2012 Sea Doo RXT series and is the answer not in the manual?

Sea-doo 2012 Sea Doo RXT series Specifications

General IconGeneral
BrandSea-doo
Model2012 Sea Doo RXT series
CategoryBoat
LanguageEnglish

Related product manuals