SUSPENSION
1
2
3
smo2009-002-114_h
1. AUTOMATIC SUSPENSION message
2. AUTO mode indicator on
3. All segments of suspension position
indicator ON
Manual Suspension Mode
MANUAL SUSPENSION mode allows
fine-tuning the suspension calibration
to theoperator'spreference. The SUS-
PENSIONHEIGHTcanbeadjustedus-
ing the iS button (UP or DOWN arrow)
on the left handlebar.
SUSPENSION HEIGHT can be ad-
justed a total of nine increments.
NOTE: Changing the suspension
height using the iS button puts the
iS system in MANUAL SUSPENSION
mode. The suspension will remain
in MANUAL SUSPENSION mode un-
til selected to AUTO SUSPENSION
mode, or until the watercraft is shut
downandpoweredupagain.
If the suspension is being used in
MANUAL SUSPENSION mode and
youwishtorevertbacktoAUTO-
MATIC SUSPENSION mode by dou-
ble-clicking the iS button (UP or DOWN
arrow). Refer to the
CONTROLS
sub-
section for more details.
Manually Adjusting Ride Height
Press the iS UP or Down arrow button
once to move the suspension to the
next height increment, or press and
hold the button until the desired ride
height is obtained.
sdd2009-001-019_d
TYPICAL
1. iS UP arrow button
2. iS Down arrow button
The following indications of manual
suspension mode can be observed in
the digital screen of the information
center:
– A scrolling message in the digital
screen that states MANUAL SUS-
PENSION.
– The AUTO indication in the iS dis-
play will disappear.
– The suspension position indicator
will indicate the relative SUSPEN-
SION HEIGHT (only one segment of
the indicator will be on).
1
2
3
smo2009-002-114_g
1. MANUAL SUSPENSION message
2. AUTO mode indicator OFF
3. Relative suspension position indication
Dock Mode
The iS system can be set to DOCK
MODE AUTO or DOCK MODE OFF.
84
______________
To Next Page
Loading...
Need help?
General