5.2. CONFIGURING THE ASTERX-U NTRIP CASTER
Figure 5-8: Connecting as a client to the AsteRx-U NTRIP Caster
On the NTRIP Client side
Rover receivers can connect to the NTRIP Caster by entering its IP address and Port as shown
in Figure 5-9. After clicking ‘Ok’, the mount point source table will be filled and a mount point
can be selected. The user name and password can then be entered and within a few seconds,
the rover receiver should report an RTK fixed position.
Figure 5-9: Connecting as a client to the AsteRx-U NTRIP Caster
59
To Next Page
