Manual – DFE32B Fieldbus Interface PROFINET IO
115
9
Communication via Ethernet
MOVITOOLS® MotionStudio – Operation
Adjusting located
Ethernet nodes to
the network
(address)
Proceed as follows to adjust (address) the localized Ethernet nodes to the network:
1. Double-click in the "Communication parameters" area of the respective unit [1].
You can now change the following settings:
• IP address of the Ethernet node
• IP address of the subnet mask
• IP address of the standard gateway
• DHCP startup configuration (if supported by the unit)
2. Transmit the address changes to the Ethernet node. Click on [Download] [2].
3. Switch the unit off and on again in order to apply the changes.
64349AXX
[1] "Communication parameters" window
[2] [Download] button
To Next Page
Loading...
