SEW-Eurodrive DFE32B PROFINET IO - Configuring Units

98
Manual – DFE32B Fieldbus Interface PROFINET IO
9
Configuring units
MOVITOOLS® MotionStudio – Operation
9.5 Configuring units
Proceed as follows to configure a unit:
1. Mark the unit (usually the power section [1]) in the network view.
2. Right-click to open the context menu and display the tools for configuring the unit.
The example shows the context menu with the tools for MOVIDRIVE
®
. The commu-
nication mode is set to "online" and the unit is scanned in the network view.
3. Select a tool (e.g. "Parameter tree") to configure the unit.
68059AEN
68060AEN
[1]