SEW-Eurodrive DFE32B PROFINET IO - Executing Functions with the Units

120
Manual – DFE32B Fieldbus Interface PROFINET IO
9
Executing functions with the units
MOVITOOLS® MotionStudio – Operation
9.10 Executing functions with the units
9.10.1 Unit parameterization
Units are parameterized in the parameter tree. It displays all unit parameters, grouped
into folders.
You can manage the unit parameters using the context menu and the toolbar. The fol-
lowing steps illustrate how to read/edit unit parameters.
9.10.2 Reading or changing unit parameters
proceed as follows to read or change unit parameters:
1. Switch to the required view (project view or network view).
2. Select the connection mode:
• Click the "Switch to online mode" button [1] if you want to read or change param-
eters directly on the unit.
• Click the "Switch to offline mode" button [2] if you want to read or change param-
eters in the project.
3. Select the unit you want to parameterize.
4. Open the context menu and select the [Parameter tree] command.
Then, the "Parameter tree" view opens on the right section of the screen.
64337AXX
[1] "Switch to online mode" icon
[2] "Switch to offline mode" icon