SEW-Eurodrive DFE32B PROFINET IO - Before You Start

Manual – DFE32B Fieldbus Interface PROFINET IO
13
4
Installing the DFE32B option card in MOVIDRIVE® MDX61B
Assembly and Installation Notes
4.1.1 Before you start
Observe the following notes before installing or removing an option card:
• Disconnect the inverter from the power. Switch off the DC 24 V and the line voltage.
• Take appropriate measures (discharge strap, conductive shoes, etc.) to protect the
option card from electrostatic charge before touching it.
• Before installing the option card, remove the keypad and the front cover (see
MOVIDRIVE
®
MDX60B/61B operating instructions, section "Installation").
• After having installed the option card, replace the keypad and the front cover (see
MOVIDRIVE
®
MDX60B/61B operating instructions, section "Installation").
• Keep the option card in its original packaging until immediately before you are ready
to install it.
• Hold the option card by its edges only. Do not touch any of the components.