SEW-Eurodrive DFE32B PROFINET IO - Read;Write Parameters via Data Set 47

Manual – DFE32B Fieldbus Interface PROFINET IO
87
7
Read/write parameters via data set 47
Parameterization via PROFIdrive Data Set 47
7.3 Read/write parameters via data set 47
7.3.1 Sample program for SIMATIC S7
The STEP 7 code stored in the GSD file shows how parameters are accessed via the
STEP 7 system function modules SFB 52/53. You can copy the STEP 7 code and im-
port/compile it as a STEP 7 source.
7.3.2 Technical data PROFINET for MOVIDRIVE
®
DFE32B
INFORMATION
• There is an example of a function module for SIMATIC S7 controls available for
download in the Software section on the SEW website (www.sew-eurodrive.de).
• This example is a special and free service that demonstrates only the basic ap-
proach to generating a PLC program. SEW is not liable for the contents of the sam-
ple program.
GSD file for PROFINET:GSDML-V2.1-SEW-DFE-DFS-2Ports-yyyy.mm.dd.xml
Module name for project planning: MOVIDRIVE
®
DFE32B
Supported data set: Index 47
Supported slot number: Recommended: 0
Manufacturer code: 10A hex (SEW-EURODRIVE)
Profile ID: 0
C2 response timeout 1 s
Max. length C1 channel: 240 bytes
Max. length C2 channel: 240 bytes
00
I