86
Manual – DFE32B Fieldbus Interface PROFINET IO
7
Structure of the PROFINET parameter channel
Parameterization via PROFIdrive Data Set 47
PROFIdrive
return codes for
PROFINET
The following table shows the coding of the error number in the PROFIdrive parameter
response according to PROFIdrive profile V3.1. This table applies if you use the
PROFIdrive services "Request Parameter" or "Change Parameter".
Error no. Meaning Used for
0x00 Invalid parameter number. Access to non-existent parameters
0x01 Parameter value cannot be
changed
An attempt was made to change a parameter value that can-
not be changed
0x02 Minimum or maximum value
exceeded
An attempt was made to change a value to one that is outside
of the limit values
0x03 Incorrect subindex Access to non-existent subindex
0x04 No assignment Access with subindex to parameter that is not indexed
0x05 Incorrect data type An attempt was made to change a replace a value with one
that does not correspond to the data type of the parameter
0x06 Setting not permitted (can
only be reset)
An attempt was made to set a value to one larger than 0
where this is not permitted
0x07 Description element cannot
be changed
Access to description element that cannot be changed
0x08 Reserved (PROFIdrive Profile V2: PPO write query for IR not available)
0x09 Description does not exist Access to description that is not accessible (parameter value
exists)
0x0A Reserved (PROFIdrive Profile V2: incorrect access group)
0x0B No operation priority An attempt was made to change a parameter without change
rights
0x0C Reserved (PROFIdrive Profile V2: incorrect password)
0x0D Reserved (PROFIdrive Profile V2: text cannot be read in cyclic data
transfer)
0x0E Reserved (PROFIdrive Profile V2: name cannot be read in cyclic data
transfer)
0x0F No text assignment avail-
able
Access to text assignment that is not accessible (parameter
value exists)
0x10 Reserved (PROFIdrive Profile V2: no PPO write)
0x11 Request cannot be exe-
cuted due to the operating
mode
Access is currently not possible and the reason is not
explained
0x12 Reserved (PROFIdrive Profile V2: other error)
0x13 Reserved (PROFIdrive Profile V2: data cannot be read in cyclic
exchange)
0x14 Incorrect value An attempt was made to change a value to one that is in the
permitted range but is not permitted due to other long-term
reasons (parameter with specified individual values)
0x15 Response is too long The length of the current response exceeds the maximum
transmittable length
0x16 Invalid parameter address Invalid value or value that is not valid for this attribute, num-
ber of elements, parameter number, subindex or a combina-
tion of these factors.
0x17 Incorrect format Write request: Invalid format or parameter data format that is
not supported
0x18 Number of values is not
consistent
Write request: Number of values of parameter data does not
correspond to the number of elements in the parameter
address
0x19 Axis does not exist Access to an axis that does not exist
up to 0x64 Reserved -
0x65..0xFF Depends on the manufac-
turer
-
To Next Page
Loading...
