SEW-Eurodrive DFE32B PROFINET IO - Startup Procedure for DFE32 B Option as Gateway

Manual – DFE32B Fieldbus Interface PROFINET IO
49
5
Startup procedure for the DFE32B option as gateway
Project Planning with PROFINET
5.6 Startup procedure for the DFE32B option as gateway
The following sections will describe the the startup procedure for a MOVITRAC
®
B with
the DFE32B PROFINET IO option as gateway step-by-step.
5.6.1 Preliminary work
Step 1: Install the required software
1. FTDI driver for USB11A programming interface
– Connect USB11A to the PC. Windows hardware detection installs the required
FTDI driver.
– The FTDI driver is available on the Software ROM 7 or on the SEW website.
2. GSD file: SEW-DFE32B-2-Port_V2.1-JJJJ.MM.TT.xml
3. MOVITOOLS
®
MotionStudio version 5.40 or later.
Step 2: Installing the devices
1. Install MOVITRAC
®
B according to the operating instructions:
– Supply system cable
– Motor cable
– Braking resistor
– DC 24 V backup voltage
2. Install PROFINET and connect gateway to PROFINET.
3. Install the system bus according to this manual.
4. Activate SBus terminating resistor at final node.