Operating Instructions – MOVIFIT® basic
63
7
Manual mode with LT-BG keypad
Operation
7.6.3 Deactivating manual operation
Deactivate manual operation by setting parameter P1-12 to "0".
WARNING
Risk of crushing due to unexpected start of the drive. The signals of the higher-level
controller become effective immediately after deactivating manual operation. The
drive runs with the speed that is specified by the higher-level controller.
Severe or fatal injuries.
• During deactivation, observe a sufficient safety distance to all parts driven by the
motor.
• or, before deactivating manual operation, make sure that the drive is not enabled
by the higher-level controller.
INFORMATION
The inverter briefly releases the brake when you set parameter P1-12 to "0".
To Next Page
Loading...
