8
Operating Instructions – MOVIFIT® basic
2
Designated use
Safety notes
2.4 Designated use
MOVIFIT
®
basic drives are components intended for installation in electrical systems or
machines.
In case of installation in machines, startup of MOVIFIT
®
basic units (i.e. start of desig-
nated operation) is prohibited until it is determined that the machine meets the require-
ments stipulated in the Machinery Directive 2006/42/EC.
Startup (i.e. the start of designated use) is only permitted under observance of the EMC
directive 2004/108/EC.
The MOVIFIT
®
basic units meet the requirements stipulated in the Low Voltage Direc-
tive 2006/95/EC. The standards given in the declaration of conformity apply to the
MOVIFIT
®
basic units.
You must observe the technical data and information on the connection requirements
as provided on the nameplate and in the documentation.
2.4.1 Safety functions
MOVIFIT
®
basic units may not perform safety functions.
2.4.2 Hoist applications
MOVIFIT
®
basic units are not designed for hoist applications.
2.5 Other applicable documentation
Note also the following documentation:
• "DR.71-225, 315 AC Motors" operating instructions
You can download or order this publication on the Internet (http://www.sew-
eurodrive.de, under the heading "Documentation").
2.6 Transportation, storage
You must observe the notes on transportation, storage and proper handling. Comply
with the requirements for climatic conditions stated in section "Technical Data".
2.7 Installation
The units must be installed and cooled according to the regulations and specifications
in the corresponding documentation.
Protect the MOVIFIT
®
basic units from improper strain.
The following applications are prohibited unless the unit is explicitly designed for such
use:
• Use in potentially explosive atmospheres.
• Use in areas exposed to harmful oils, acids, gases, vapors, dust, radiation, etc.
• Use in non-stationary applications with strong mechanical oscillation and impact
loads; see section "Technical Data".
To Next Page
Loading...
