DAPNET connector
You can use this connector to connect to a network which supports the
DAPNET protocol.
The easiest way is to use the Quick setup to connect to these servers.
This connector supports the POCSAG modem protocol which is the protocol
used by pagers. You can find more information about POCSAG and DAPNET
here.
The openSPOT4 acts as a transmitter on DAPNET, so make sure you use your
DAPNET transmitter login and auth key for connecting the openSPOT4. These
are not the same as your DAPNET user account. A separate transmitter
registration is needed. See this page for more information.
To Next Page
Loading...
