SharkRF openSPOT - Dcs;Xlx; Ref;Xrf

DMR transceiver
91
Server and room change using a D-STAR® radio (openSPOT4 Pro
only)
DTMF method
Enter DTMF code * followed by the special ID described below.
URCALL/your call method
Set the URCALL to the FCS server and room number. Example: starting a call to
destination callsign (URCALL) FCS00199 switches to FCS001 room 99.
The URCALL/your call method lets you change to the following server types:
REF/XRX/Gateway: set the URCALL to for example REF001 C . Switching to
REF/XRF servers or gateways this way changes the openSPOT4's active
connector to the REF/XRF connector.
DCS/XLX: set the URCALL to for example DCS001 A . Switching to DCS/XLX
servers this way changes the openSPOT4's active connector to the DCS/XLX
connector.
BrandMeister: set the URCALL to BM followed by the BrandMeister server
ID. Example: starting a call to destination callsign (URCALL) BM2162
switches to BrandMeister server 2162 (Hungary). Switching to BrandMeister
servers this way changes the openSPOT4's active connector to the
Homebrew/MMDVM connector.
FCS: set the URCALL to the FCS server and room number. Example:
starting a call to destination callsign (URCALL) FCS00199 switches to
FCS001 room 99. Switching to FCS servers this way changes the
openSPOT4's active connector to the FCS connector.
YSFReflector: set the URCALL to YS followed by the YSFReflector server
ID. Example: starting a call to destination callsign (URCALL) YS89804
switches to YSFReflector 89804 (AmericaLink). Switching to YSFReflector
servers this way changes the openSPOT4's active connector to the
YSFReflector connector.
NXDNReflector: set the URCALL to NX followed by the NXDNReflector
server ID. Example: starting a call to destination callsign (URCALL) NX28299
switches to NXDNReflector 28299 (America-Ragchew). Switching to
NXDNReflector servers this way changes the openSPOT4's active connector
to the NXDNReflector connector.
You can switch the cross mode DGID sent to the network using a D-STAR®
transceiver by entering DTMF code # followed by the desired DGID. For example,
if you want to set the cross mode DGID to 25, enter DTMF #25. If you only
enter # then the cross mode DGID will be reset to 0.
Special IDs for server and room change
The format of the ID to call with your DMR, NXDN® or P25 radio, or the ID to
enter using DTMF codes on your D-STAR® radio can be the following:
room number or
server number + room number