D-STAR®: call is sent to .......1 (7 spaces and the configuration profile
number, replace dots with spaces), or DTMF code A is entered followed by
the configuration profile number.
C4FM: Special command/cross mode private call DTMF code (by default it's
*) is entered followed by DTMF code A, then the desired configuration
profile number.
Connector status query
The currently active connector's status can be queried by calling the following
IDs/callsigns:
DMR, NXDN® and P25: ID 9998. Both private and group calls are
interpreted.
D-STAR®: call is sent to .......I (7 spaces and an I, replace dots with
spaces), or DTMF code D or 0 is entered.
C4FM: Special command/cross mode private call DTMF code (by default it's
*) is entered followed by DTMF code D.
The connector status will be announced by voice. The DMR/NXDN®/P25
connector status query ID can be changed on the Settings page, Voice
announcements section.
Active IP address query
The active IP address can be queried by calling the following IDs/callsigns:
DMR, NXDN® and P25: ID 9997. Both private and group calls are
interpreted.
D-STAR®: call is sent to .......A (7 spaces and an A, replace dots with
spaces), or DTMF code B is entered.
C4FM: Special command/cross mode private call DTMF code (by default it's
*) is entered followed by DTMF code B.
The IP address will be announced by voice. The DMR/NXDN®/P25 IP address
query ID can be changed on the Settings page, Voice announcements section.
Battery status query
The battery status can be queried by calling the following IDs/callsigns:
DMR, NXDN® and P25: ID 9996. Both private and group calls are
interpreted.
D-STAR®: call is sent to .......B (7 spaces and an B, replace dots with
spaces), or DTMF code C is entered.
C4FM: Special command/cross mode private call DTMF code (by default it's
*) is entered followed by DTMF code C.
The battery status will be announced by voice. The DMR/NXDN®/P25 battery
status query ID can be changed on the Settings page, Voice announcements
section.
To Next Page
Loading...
