SharkRF IP Connector Client connector
You can use this connector to directly connect to another openSPOT device, or
a server which supports the SharkRF IP Connector protocol, or our open source
SharkRF IP Connector Protocol Server. The protocol's documentation can be
found on GitHub, so you can also develop your own application for the
openSPOT4.
The easiest way is to use the Quick setup to connect to a SharkRF IP Connector
server.
If you want to connect directly to another openSPOT or openSPOT4, make sure
that the another device is set up as the server, and the UDP port used by this
connector (by default it's 65100) is correctly set up on the server's router (it's
open on the firewall and is forwarded to the server openSPOT1/2/3 on its local
network).
All modem modes are supported by this connector, with automatic cross mode
conversion between the following modes:
DMR, C4FM (DN mode) and NXDN®, and also D-STAR® with the
openSPOT4 Pro
C4FM (VW mode) and P25
To Next Page
Loading...
