Modem mode notes:
DMR: voice announcements are sent to TG9, so to hear them, make sure
you have TG9 in your radio's RX group list.
NXDN®: voice announcements are sent to TG0.
P25: voice announcements are sent to TG9.
If the battery charge percentage is 15% or below, and the
Enable battery low
announcement
is turned on, then the openSPOT4 transmits battery charge
status voice announcements every 5 minutes.
If the
Time announcement interval
is set, then the openSPOT4 will periodically
announce current time. Interval is calculated from midnight, so for example if it
is set to every 3 hours, then it will announce current time at 3AM, 6AM, 9AM
and so on. Before announcing the time, the openSPOT4 checks if a call came
from the network or the modem in the last 10 seconds. If yes, the time
announcement will be skipped so it won't interfere with ongoing calls.
If you enable
Advanced mode
, the following settings will show up:
You can shorten profile announcements by checking the Shortened profile
announcement checkbox.
If you don't want to hear the linked reflector/talkgroups list, then you can
shorten BrandMeister announcements by checking the Shortened
BrandMeister announcement checkbox.
You can disable built-in voice announcements by checking the Use server
only checkbox. Note that startup voice announcements played right after
the openSPOT4 boots will still be played from the openSPOT4's flash
memory.
You can set your own voice announcement server's host and port.
Net state announcement int. sets the interval of the announcement if the
openSPOT4 can't connect to a Wi-Fi network.
See the Control calls section for more information about Profile query/change
base ID, Connector query ID, IP address query ID, Battery status query ID, and
Time query ID.
Location settings
To Next Page
Loading...
