Try remote module E on any reflector for the REF/XRF echo service (may not
enabled on some servers).
Switching reflectors/gateways using your radio
URCALL/your call method
You can switch reflectors using your radio by starting a short call to their names
as the destination callsign (URCALL), like REF001 A , or XRF001 A . Set the desired
remote module as the last character of the URCALL. You can switch to
gateways the same way.
The URCALL/your call method lets you change to the following server types:
REF/XRX/Gateway: set the URCALL to for example REF001 C . Switching to
REF/XRF servers or gateways this way changes the openSPOT4's active
connector to the REF/XRF connector.
DCS/XLX: set the URCALL to for example DCS001 A . Switching to DCS/XLX
servers this way changes the openSPOT4's active connector to the DCS/XLX
connector.
BrandMeister: set the URCALL to BM followed by the BrandMeister server
ID. Example: starting a call to destination callsign (URCALL) BM2162
switches to BrandMeister server 2162 (Hungary). Switching to BrandMeister
servers this way changes the openSPOT4's active connector to the
Homebrew/MMDVM connector.
FCS: set the URCALL to the FCS server and room number. Example:
starting a call to destination callsign (URCALL) FCS00199 switches to
FCS001 room 99. Switching to FCS servers this way changes the
openSPOT4's active connector to the FCS connector.
YSFReflector: set the URCALL to YS followed by the YSFReflector server
ID. Example: starting a call to destination callsign (URCALL) YS89804
switches to YSFReflector 89804 (AmericaLink). Switching to YSFReflector
servers this way changes the openSPOT4's active connector to the
YSFReflector connector.
NXDNReflector: set the URCALL to NX followed by the NXDNReflector
server ID. Example: starting a call to destination callsign (URCALL) NX28299
switches to NXDNReflector 28299 (America-Ragchew). Switching to
NXDNReflector servers this way changes the openSPOT4's active connector
to the NXDNReflector connector.
Alternatively you can set up different configuration profiles with different servers
activated, and switch between the configuration profiles using your transceiver.
DTMF method
Here are some example DTMF command sequences:
Switching to REF servers:
*1C or *01C or *001C connects to REF001 module C.
Switching to XRF servers:
To Next Page
Loading...
