NXDNReflector connector
You can use this connector to connect to a network which supports the
NXDNReflector protocol, like NXDNReflector servers.
The easiest way is to use the Quick setup to connect to these networks.
Talkgroup handling
NXDNReflector servers handle only one talkgroup. You can find each server's
talkgroup ID in the server list, or if you enable
Advanced mode
, then the
talkgroup ID setting will be shown.
If you use NXDN® modem mode, then make sure you send your calls as a
group call to the talkgroup ID, otherwise the server will ignore your calls.
Also make sure you have the talkgroup ID in your SelCall list (if SelCall is
enabled), otherwise you won't hear incoming calls on your radio.
If you use cross modes, then send your calls as a group call to the talkgroup
ID, otherwise the server will ignore your calls.
If you use a DMR radio, then make sure the talkgroup ID is set as the TX
contact for the current channel in your radio, or the talkgroup ID is in an RX
group list which is assigned to the current channel of your radio, otherwise
you won't hear incoming calls from the server.
You can also set the Default cross mode destination ID to the talkgroup ID
and enable Always use this ID in cross mode. These settings are available
on the Settings page, NXDN® settings section. This way your cross mode
calls will be always sent to the correct talkgroup ID.
Switching NXDNReflector servers using your radio
You can switch NXDNReflector servers with your radio by calling the desired
server's ID with a private call.
Cross mode usage
To Next Page
Loading...
