B8B or B08B or B008B connects to XRF008 module B.
Switching to XLX servers:
C5B or C502 or C0502 will change the active connector to the DCS/XLX
connector and connects to XLX005 module B.
C9D or C904 or C0904 will change the active connector to the DCS/XLX
connector and connects to XLX009 module D.
Switching to DCS servers:
D5A or D501 or D0501 will change the active connector to the DCS/XLX
connector and connects to DCS005 module A.
D1C or D103 or D0103 will change the active connector to the DCS/XLX
connector and connects to DCS001 module C.
Notes
The openSPOT4 will automatically set the local module to a space character if
you are switching to a gateway, and to local module D if you are switching to a
reflector using your radio.
Cross mode usage (openSPOT4 Pro only)
The REF/XRF connector is a D-STAR® connector, but it supports DMR, C4FM
and NXDN® cross modes with the openSPOT4 Pro.
Server change using a DMR or NXDN® radio
You can change servers using a DMR or NXDN® radio with a private call to a
special ID described below.
Server change using a C4FM radio
You can change servers by entering the Special command/cross mode private
call DTMF code (by default it's *) or the Cross mode group call DTMF code] (by
default it's #) followed by the special ID described below.
You can also use the Wires-X® button menu of your radio to select/search for
servers.
Special IDs for server change
The format of the ID to call with your DMR or NXDN® radio, or the ID to enter
using DTMF codes on your C4FM radio can be the following:
server type + module number or
server type + server number + module number
Server type can be:
1: REF
2: XRF
3: XLX
To Next Page
Loading...
