YSFReflector connector
You can use this connector to connect to a network which supports the
YSFReflector protocol, like YSFReflector servers.
The easiest way is to use the Quick setup to connect to these networks.
Advanced settings
If you enter IDs into the DGID list, then they will be sent to the server. The
server will link the specified DGIDs/rooms if it supports this functionality.
Switching YSFReflector servers using your radio
You can switch YSFReflector servers with your radio by entering the Special
command/cross mode private call DTMF code (by default it's *) or the Cross
mode group call DTMF code (by default it's #) followed by the desired server's ID
(5 digits).
You can also use the Wires-X® button menu of your radio to select/search for
servers.
Cross mode usage
The YSFReflector connector is a C4FM connector, but it supports DMR, NXDN®
and P25 cross modes, and D-STAR® with the openSPOT4 Pro.
Using a DMR, NXDN® or P25 transceiver
You can change servers using DMR, NXDN® and P25 transceivers by calling
their IDs with a private call.
You can switch the cross mode DGID sent to the network by making a short
group call to 4000 + the desired DGID number. For example, if you want to set
the cross mode DGID to 25, start a short group call 4025. To reset the DGID to
0, start a short group call to 4000.
Using a D-STAR® transceiver (openSPOT4 Pro only)
To Next Page
Loading...
