The source NXDN® ID of your DMR calls will be set to the same value as the
DMR call unless the Always use this ID in cross mode setting is enabled for the
Default cross mode source ID on the Settings page, NXDN® settings section.
Your DMR calls will be sent to the same NXDN® ID as the DMR call's destination
ID unless the Always use this ID in cross mode setting is enabled for the
Default cross mode destination ID on the Settings page, NXDN® settings
section, or the destination DMR ID is out of the NXDN® ID range (0-65535). In
this case, the Default cross mode destination ID will be used for the NXDN®
call.
The destination and source DMR IDs for an incoming NXDN® call will be set to
the same value as the incoming call's destination and source ID unless the
Always use this ID in cross mode setting is enabled for the destination/source
NXDN® IDs on the Settings page, NXDN® settings section.
Make sure the destination ID of the NXDN® calls (the NXDN® talkgroup) is the
TX contact of your DMR radio's current channel, or it's in an RX group list which
is assigned to the current channel in the radio, otherwise the squelch won't
open and you won't hear the calls.
To Next Page
Loading...
