will be used. The default ID will be used if the Always use this ID in cross
mode setting is enabled for the Default cross mode source ID on the Settings
page, NXDN® settings section.
The callsign of incoming NXDN® calls will be set to the callsign associated with
the NXDN® ID. If there's no callsign associated in the database, then the Default
callsign for cross mode calls will be used. If it's not set, the callsign will be the
source NXDN® ID as text.
Using a P25 network
After you've set up and activated the P25 connector, switch the modem to
C4FM mode (or C4FM Half Deviation mode, if your radio needs that). Only calls
in VW (Voice Wide) mode will be converted, if you transmit in other modes,
P25 users will only hear silence.
The source P25 ID of your calls from the C4FM radio will be set to the ID
associated with the source callsign. If there's no ID associated, then the source
callsign will be parsed into a number and this will be used as the source P25 ID.
If it can't be parsed into a number, then the Default cross mode source P25 ID
will be used. You can set this to your DMR/P25/CCS7 ID.
The callsign of incoming P25 calls will be set to the callsign associated with the
P25 ID. If there's no callsign associated in the database, then the Default callsign
for cross mode calls will be used. If it's not set, the callsign will be the source
P25 ID as text.
To Next Page
Loading...
