Sharp ER-A347 - Report Configuration; Zero Skip

74

■
Zeroskip
You can program whether or not to skip “0” in each report.
Procedure
Program each item as follows:
•DEPARTMENT(Usetheselectiveentry)
SKIP: Skips those data that are “0” in the department
report.
NOT SKIP: Does not skip those data that are “0” in the
department report.
•TRANSACTION(Usetheselectiveentry)
SKIP: Skips those data that are “0” in the transaction
report.
NOT SKIP: Does not skip those data that are “0” in the
transaction report.
•PLU(Usetheselectiveentry)
SKIP: Skips those data that are “0” in the PLU/UPC report.
NOT SKIP: Does not skip those data that are “0” in the PLU/UPC report.
•CLERK(Usetheselectiveentry)
SKIP: Skips those data that are “0” in the clerk report.
NOT SKIP: Does not skip those data that are “0” in the clerk report.
•HOURLY(Usetheselectiveentry)
SKIP: Skips those data that are “0” in the hourly report.
NOT SKIP: Does not skip those data that are “0” in the hourly report.
•DAILYNET(Usetheselectiveentry)
SKIP: Skips those data that are “0” in the daily net report.
NOT SKIP: Does not skip those data that are “0” in the daily net report.