Sharp MXC301W - Page 623

7-36
SYSTEM SETTINGS
Contents
Printer Settings
Image Send Settings
Item Factory default setting Page
■ Printer Settings
7-77
● Default Settings 7-77
X Prohibit Notice Page Printing Enabled 7-77
X Prohibit Test Page Printing Disabled 7-77
X A4/Letter Size Auto Change Disabled 7-77
X Print Density Level
7-77 Color 3
 Black & White 3
X CMYK Exposure Adjustment 0 7-77
X Bypass Tray Settings 7-77
 Enable Detected Paper Size in Bypass Tray Disabled 7-77
 Enable Selected Paper Type in Bypass Tray Disabled 7-77
 Exclude Bypass-Tray from Auto Paper Select Disabled 7-77
X Job Spool Queuing Enabled 7-77
X Disabling of USB Memory Direct Print Disabled 7-77
X Disabling of Network Folder Direct Print Disabled 7-77
● Interface Settings 7-78
X Hexadecimal Dump Mode Disabled 7-78
X I/O Timeout 60 sec. 7-78
X Enable USB Port Enabled 7-78
X USB Port Emulation Switching Auto 7-78
X Enable Network Port Enabled 7-78
X Network Port Emulation Switching Auto 7-78
X Port Switching Method Switch at End of Job 7-78
● Auto Color Calibration – 7-79
Item Factory default setting Page
■ Image Send Settings
7-80
● Operation Settings 7-80
X Other Settings 7-80
 Default Display Settings Scan (fax when fax is installed) 7-80
 Hold settings for a while after scanning has been completed Disabled 7-80
 Address Book Default Selection Tab Switch: ABC, Address Type: All 7-80