Shenzhen Hongdian Technologies H7920 User Manual

Hongdian Corporation
40
H792x 3G/4G Router User Manual
Step 3 Configure SNMP parameter.
Table 5-8 SNMP Parameter instruction
Parameter
Details
Operation
SNMP service
To enable or disable SNMP service
Options:

Enable

Disable
Basic Config
Port
SNMP port, suggest to be default
port161
Value area: 1～65535
Default: 161
Community
Community Password of SNMP
client to router SNMP, Used for
identification
WORD type, max 16
bytes
Trap IP
Link-state router report server
address
Manual input
Format：A.B.C.D/Mask
Trap Port
Link-state router report server
address’s port
Value area：1～65535
Default：162
Loopback
Status
Match with "LAN" page loopback
address, in the "Loopback Status" to
"Enable", means loopback address
configuration successfully, the
router reported Trap IP packet
source address is the loopback
address, If the "Loopback Status" to
"Disabled" means router IP packet
source address for the LAN port
address
Options:

Enable

Disable
Step 4 Single click “save” icon to finish SNMP configuration.
MIB for SNMP can be downloaded from our websi te, i f necessary, please conta ct our technical engineers .
---END
5.3.4 M2M configuration
H792x 3G/4G router has embedded a WMMP (Wireless Machine-to-Machine Protocol)
protocol to realize communication with M2M (Machine-to-Machine) platform which can
remotely monitor and manage the routers and its network, e.g. visit the router, patch
upgrading, firmware upgrading, parameter configuration, monitor the network strength,
time delay, flow. Its configuration is as follows:

Shenzhen Hongdian Technologies H7920 Specifications

General

Brand	Shenzhen Hongdian Technologies
Model	H7920
Category	Network Router
Language	English