H792x 3G/4G Router User Manual
Step 15 Single click “save” icon to finish.
MASQ rule: the source address of all packets in the LAN need to be transferred into the specifi c ip
address of the router, so the PC from the LAN can send packets out; If MASQ rule in the router will be
deleted, the router LAN of the PC cannot communicate with external network.
---END
5.5.3 Static Routing
Static routing can forward packets according that the user configured specific forwarding
path manually. Static Routing form is divided into static routing and policy routing, static
routing is based on the destination address as an alternative route; while policy route is
based on the source address that match with the policy to forward the packets
(forwarding router detects the received packet's source address, and then forward
packages according to the source which matches policy route) and policy routing priority,
use numbers 3 to 252 to differentiate, the smaller number with higher priority. And there
are priorities between static routing and policy routing: policy routing higher priority than
static routing.
Step 1 Log-on WEB GUI of H792x 3G/4G router.
Step 2 Click “Forward > Routing” to open “NAT” tab, as Figure 5-49.
Figure 5-30 Static Routing Interface
Step 3 Click “Add” to add a new static route, configure interface as Figure 5 -50 and Figure 5-51.
To Next Page
Loading...
Need help?
General