Shimadzu GC-2014 Series - Flow Adjust (Detapc); Flow Adjust (aux APC)

Chapter 8 Service Window
GC-2014 Service Manual
111
8.2 Flow Adjust (DetAPC) (Options only)
A
s an example, the window on the left shows the items
displayed for H
2
. The items are the same, however, for the
A
PCs of air and make-up gas. The displayed contents may
vary, however, depending on the type of Det APC.
Default value (same for air, H
2
, and make-up gas)
Default value (same for air, H
2
, and make-up gas)
Default value (same for air, H
2
, and make-up gas)
pf4: ROM wrt
pf5: BASE, INJECTION UNIT A ASSY
8.3 Flow Adjust (AUX APC)
Default value
Default value
Default value
pf4: ROM wrt
pf5: Offset
There is no display for AUX APCs that have not been
installed.