Chapter 2 Configuration of GC-2014
GC-2014 Service Manual
25
2.2.8 Fan
When the fan (P/N: 221-28247) is mounted onto the motor shaft and pushed to the
position where it touches the back of the oven, if the motor shaft protrudes at least 5 mm
in the front of the fan, mount the fan with its outer face (i.e., the back) in alignment with
the end of the shaft. If the motor shaft protrudes less than 5 mm, then the fan must be
pulled forwards so that the outer face is an appropriate distance in front of the end of
shaft. It is secured in this state using the screw provided with the fan.
The screw is on the
motor side.
Back of oven
Back of fan
Rotate the fan to check
that it does not hit the tab.
(Align the back of the fan
with the end of the shaft.)
Motor axis
5 to 5.5 mm
Fan screw
Motor axis
When securing the fan to the
motor shaft, orient it so that
the screw makes contact with
the flat side of the shaft.
To Next Page
Loading...
