Test Spin Page -1-
Take a Test Spin
Next we'll go for a quick trial spin with your tool and do a few tests to make sure things are
working as they should be. Then you'll be ready to start putting your ShopBot to work for
you!
Run Your ShopBot Now and Check out Some of its Basic Functions.
Start the Control Box. If your tool is a PRSalpha, also hit the blue “Reset” button on the box
(this activates the relay systems). Your first moves will just be 'air' cuts, so you do not need
to have a bit.
Start the ShopBot Control Software. The icon to start the Control Software is
labeled “ShopBot 3” and should show up on your Windows Desktop. Double
click it to start the software.
TestSpinPRS080916 Copyright 2008 ShopBot Tools, Inc
If this is the first time you have run the software, you will be prompted to
select your tool type from a list. (If you get it wrong, you can correct later with Utilities >
Reset.)
st
t of the Preview Mode and into
ove/Cut Mode. The connection process will start.
t Tool cannot be established, a yellow screen will come up with
for you to try.
As the ShopBot Control Software begins to start, it should indicate that it is “trying to
connect” to your ShopBot If you have run the software in Preview Mode previously, ju
click the ‘Move’ Switch on the Red Panel to switch ou
M
If a connection to a ShopBo
suggestions
To Next Page
Loading...
