50 GMS800 · Operating Instructions · 8013025 V1.2 · © SICK MAIHAK GmbH
Shutdown
Subject to change without notice
7.6 Shipping for repair
When the device is being sent to the manufacturer or a Service company for repairs:
Please enclose the following information so that the device can be repaired as quickly as
possible:
b
An error description, as precise as possible (meaningful keywords suffice).
b
For unclear functional problems: A short description of the operating conditions and
installations (connected devices etc.).
b
If shipping was agreed with the manufacturer: The contact person at the manufac-
turer's who is informed about the matter.
b
A contact person in the user's company (for possible questions).
7.7 Disposal
These subassemblies could contain materials which may require special disposal:
● Sample gas paths: Toxic materials in the sample gas could have been absorbed or
trapped in the »soft« gas path material (e.g. hoses, sealing rings).
● Sample gas filter: Sample gas filters can be contaminated with pollutants.
● Electronics: Electrolyte capacitors, tantalum capacitors
● Display: Liquid of the Liquid Crystal Display (LCD)
Please add the information even if your matter has already been discussed
with a manufacturer's employee.
CAUTION: Risk of environmental hazards
b
Observe the information in these Operating Instructions.
b
Observe local regulations and laws on disposal of industrial waste and
electric devices.
WARNING: Health hazards through dangerous gases
If the GMS800 is used to measure toxic or dangerous gases:
b
Thoroughly purge all sample gas paths with a neutral gas (e.g. nitrogen)
before opening sample gas paths or components carrying sample gas.
To Next Page
Loading...
