Operating Instructions FLOWSIC100
Gas Velocity Monitor
About this Document
8012513/03-2008
©
SICK MAIHAK GmbH · Germany · All rights reserved 7
About this Document
These operating instructions describe the FLOWSIC100 measuring system, which is
designed to perform no-contact measurements of the gas velocity and temperature, or the
volumetric flow rate.
These operating instructions contain general information on the method of measurement
used, the design and function of the entire system and its components, as well as
instructions for planning, assembly, installation, commissioning and maintenance.
A comparison of the characteristics of the available system variants is provided to help you
decide on the configuration that is best suited to your needs in the planning phase.
These operating instructions only cover standard applications that match the technical data
listed. Your SICK MAIHAK representative will gladly provide you with additional information
and support for special applications. We strongly advise that you contact a SICK MAIHAK
specialist for consultation with regard to special applications.
Notes: • Always read these operating instructions carefully before commencing work. The safety
instructions and warnings must be followed at all times.
• Some system components (such as the side-channel compressor of the purge-air units)
are supplied with separate user information. This information must also be read
carefully.
Symbols used in this document
For quick access and reasons of clarity, important safety information is specially highlighted
in these operating instructions. These symbols are provided at the points in this
documentation where the relevant information is required.
Note: A note provides information on the features of the device or system, along with additional
tips.
Important
The ‘‘Attention” sign indicates a risk of damage to the device or system components and
potential functional impairments.
Warning
The ‘‘Warning” sign identifies potential danger for personnel, particularly due to electrical
equipment or as a result of incorrect handling of the device or system components. These
warnings are intended to protect you from (fatal) injuries.
Always read warnings carefully and follow them at all times!
To Next Page
Loading...
