57
8012428/YWL2/3-0/2016-08| SICK O P E R A T I N G I N S T R U C T I O N S | DUSTHUNTER T
Subject to change without notice
START-UP AND PARAMETER SETTINGS 4
4 Start-up and Parameter Settings
4.1 Basics
4.1.1 General information
Assembly and installation must have been completed according to Section 3 before
starting the work described in the following.
Start-up and parameter setting comprise:
● Setting the measuring system to the duct dimensions
● Fitting and connecting the sender/receiver unit and reflector
● Customizing parameter settings according to the respective requirements.
To achieve exact measurement, the measuring system must first be calibrated using a
gravimetric comparison measurement (see “Calibration for dust concentration mea-
surement”, page 80) before being used for continuous measurement of dust content.
To Next Page
Loading...
