MOUNTING 4
8011325/18IM/2020-07-02|SICK
Subject to change without notice
OPERATING INSTRUCTIONS | ICR880/890
4.2.2 Tools and auxiliary equipment
• Project-specific dimensional drawing
• Key for hexagon socket (6 mm) appropriate for all screws
• Measuring tape
• Protractor
4.2.3 Selecting the mounting location
The general requirements for the mounting location are described in detail in chapter
3.2.1 Mounting requirements.
The project-specific details regarding the positioning of the components as well as the
distances, angles, etc., are outlined in a dimensional drawing. These details must be
observed during mounting.
Terminal compartment
During the mounting procedure, ensure that the terminal compartment of the camera on
the device underside is freely accessible.
Fig. 18: Terminal compartment for camera and illumination unit
Terminal compartment required:
L x W x H: 496 mm x 250 mm x 210 mm
To Next Page
Loading...
