SICK ICR880 Generation 3

ELECTRICAL INSTALLATION 5
51
8011325/18IM/2020-07-02|SICK
Subject to change without notice
OPERATING INSTRUCTIONS | ICR880/890
The following interfaces are controlled via the connections on the underside of the camera:
No.
Connection
Design
No. of pins
Function
1
CAN 1-OUT
M-12
5, female
connector
Output for CAN-SENSOR network 1
CAN 1-IN
M-12
5, male
connector
Input for CAN-SENSOR network 1
2
ILLUMINATION
M-12
8, female
connector
Control data interface for the illumination
unit
3
HOST ETHERNET
M-12
5, female
connector
Communication interface (10/100 Mbit/s)
4
POWER IN
Harting
HanQ8
8, male
connector
Input for DC 24 V voltage supply
5
POWER OUT
Harting
HanQ8
8, female
connector
DC 24 V output for the illumination unit
6
AUX
M-12
8, male
connector
Auxiliary data interface (RS-232)
7
GBIT 1
ETHERNET
RJ-45
8, female
connector
Image data output, channel 1
GBIT 1
ETHERNET
RJ-45
8, female
connector
Image data output, channel 2
Tab. 13: Camera – function of the electrical connections
Special devices
In the case of some camera variants, two USB ports (female connectors, type A) are
additionally accessible via the optional connection on the side covered by a round metal
cap. These ports are for inserting dongles only. In normal read mode, the metal cap must
be screwed down.
ICD890-xxxxxxxS03
Devices of the ICD890-xxxxxxxS03 variant have three Gbit Ethernet connections with M12
plug connector. The HOST ETHERNET connection is not available here.
Fig. 38: Camera – ICD890-xxxxxxxS03 electrical connections
No.
Connection
Design
No. of pins
Function
1
3
GBIT 1
Ethernet
GBIT 3
ETHERNET
M12
8, female
connector
Connection to configuration PC with
SOPAS-ET via Ethernet
Image data output, channel 1 and 3