SICK ICR880 Generation 3

8 TROUBLESHOOTING
94
8011325/18IM/2020-07-02|SICK
OPERATING INSTRUCTIONS | ICR880/890
Subject to change without notice
8.2.2 System information
The camera system outputs any occurring faults in different ways. Fault output is
staggered, allowing for an increasingly detailed level of analysis:
• Communication errors can occur when transmitting telegrams to the camera system.
The camera system then returns a fault code.
• For faults that occur during reading, fault codes are written to a status log.
8.2.3 Status log
• The status log is retained even after switching the camera system off and on again.
• The system distinguishes between four types of fault:
– Information
– Warning
– Fault
– Critical fault
The camera system saves only the last five entries for each fault type.
Displaying the status log using the SOPAS-ET configuration software
▸
Go to the SOPAS project tree and select the following entry:
ICR8xx
 Service  System Status.
Please contact SICK Support for a more detailed analysis of the fault situation.
Note
Note