6 COMMISSIONING AND CONFIGURATION
8011325/18IM/2020-07-02|SICK
OPERATING INSTRUCTIONS | ICR880/890
Subject to change without notice
3. Select the device family from the list (in this case, ICR8xx). This restricts the search for
connected devices to devices from that family. Click Next to confirm your selection.
4. Specify which interface is to be used for the configuration work. If, as shown in the
example, the configuration is to take place using an Ethernet cable, place a check in
the check box labeled Ethernet communication (TCP/IP).
5. Confirm the following pages of the wizard by pressing Next each time and click
Complete to finish configuring the search settings.
To Next Page
Loading...
