IDM corded
© SICK AG · Germany · All rights reserved · Subject to change without notice
3.5.2 Delay Settings
Family Code Selection P.C. Parameter Selection Option Code
Intermessage Delay
SS None FIN
MS 01-99 (x5) msec. (2 digits)
Scan 2 digits from the option code chart in the Appendix;
then the scanner will terminate this selection automatically.
Intercharacter Delay
SS None FIN
MS 01-99 (x5) msec. (2 digits)
Scan 2 digits from the option code chart in the Appendix;
then the scanner will terminate this selection automatically.
Interfunction Delay
SS None FIN
MS 01-99 (x5) msec. (2 digits)
Scan 2 digits from the option code chart in the Appendix;
then the scanner will terminate this selection automatically.
Intermessage Delay: is a time delay between messages outputted by the Hand-held scanner. Increasing this
delay will help host applications to process the incoming data on time.
Intercharacter Delay: is a time delay between data characters outputted by the Hand-held scanner. These two
parameters are used to synchronize data communication when: 1) the data transmission speed is too fast,
characters may be skipped; 2) multitasking operation system or host computers in a network may slow down
the keyboard handling; 3) various notebook or desktop PC systems require different timing parameter
settings. It is recommended to always add one extra unit as safety margin when adjusting these two
parameters.
Interfunction Delay: is a time delay of between transmission and reception of each segment of the message
string.
Intermessage, Intercharacter and Interfunction Delay are not available for IDM Bluetooth scanners
working in SPP or HID mode.
To Next Page
Loading...
Need help?
General