SICK IDM 1 Series - Create a Quick Pair Barcode for SPP Master Mode

Appendix 8
8028134/2023-03-06
© SICK AG · Germany · All rights reserved · Subject to change without notice
57
8.3.3 Create a Quick Pair Barcode for SPP Master Mode
You can create an SPP master mode barcode to rapidly pair a scanner with your Bluetooth-enabled host device.
1. Look for the host device’s MAC address under its settings.
2. Use the MAC address and a barcode generator to create a Quick Pair Barcode for your host device.
3. The barcode’s symbology should be Code 128, and its format ought to be as follows:
<Fnc 3>Sxxxxxxxxxxxx
S is the prefix
xxxxxxxxxxxx represents the 12 characters of the MAC address
For example, if the host device’s MAC address is “22 22 22 11 11 11”, the barcode will be:
S222222111111