To Next Page
R
Rachel LynnSep 9, 2025
What to do if key switch does not work on Siemens FC361?
- KKelsey GonzalesSep 9, 2025
If the key switch on your Siemens Control Panel is not working, check the cable connection. If it still doesn't work, replace the device.
What to do if key switch does not work on Siemens FC361?
If the key switch on your Siemens Control Panel is not working, check the cable connection. If it still doesn't work, replace the device.
What to do if LED indication module does not work on Siemens FC361?
If the LED indication module on your Siemens Control Panel is not working, check the cable connection. If it still doesn't work, replace the device.
Why does my Siemens Control Panel LCD display 'Need calibrate'?
The 'Need calibrate' message appears on the LCD of your Siemens Control Panel because the line topology or configuration parameters have been altered, impacting the line's power consumption. To resolve this, recalibrate the line.
General| Brand | Siemens |
|---|---|
| Model | FC361 Series |
| Category | Control Panel |
| Language | English |
Outlines general safety notices and symbols used.
Covers national standards, legislation, and electrical installation safety.
General instructions and warnings for panel installation.
Step-by-step guide for surface mounting the panel.
Details on connecting the panel to the mains power supply.
Information on connecting and selecting batteries for emergency power.
Explains the C-NET detector line, capacity, and devices.
Explains panel access levels, passwords, and user roles.
Step-by-step guide for handling alarms when no personnel are present.
Step-by-step guide for handling alarms when personnel are present.
Steps to follow when a fault is detected on the system.
How to perform an automatic system configuration.
Procedure to reset the detection module when it reports a fatal fault.
Procedure for resetting the panel to its factory default settings.
Steps for connecting a PC to the panel for configuration.
Procedures for installing and checking detector lines.
Steps for installing the FC360 fire control panel.
Initial startup procedure for the panel.
General steps to follow during system commissioning.
How to perform a function test on the installed system.
Final steps to complete the commissioning process.
Procedure for updating the panel's firmware.
General information and recommendations for system maintenance.
Explains fault indications and their causes/actions.
