50 RM400 C Models U24802-J-Z146-2-7600
5
Installing peripherals
Token Ring LAN controller (EISA)
Figure 20: Token Ring LAN controller (EISA) (CL31) - (optional) -
This LAN controller will accept two types of LAN cable, either unshielded twisted-pair
(UTP) or shielded twisted-pair (STP). You cannot use both ports on this LAN
controller at the same time.
Ê To attach LAN cables of type UTP (unshielded twisted-pair) you use the left-
hand port. The connector must lock into place.
Ê To attach LAN cables of type STP (shielded twisted-pair) you use the right-
hand port. Secure the connector by tightening the locking screws.
Token Ring LAN controller (PCI)
Figure 21: Token Ring LAN controller (PCI) (CL32) - (optional) -
This LAN controller will accept two types of LAN cable, either unshielded twisted-pair
(UTP) or shielded twisted-pair (STP). You cannot use both ports on this LAN
controller at the same time.
The LAN cables are attached as described above.
left-hand port unshielded twisted-pair (UTP)
right-hand port shielded twisted-pair (STP)
left-hand port unshielded twisted-pair (UTP)
right-hand port shielded twisted-pair (STP)
To Next Page
Loading...
Need help?
General
