Data blocks / error lists
C.1 Content of the channel DB
FM 352 electronic cam controller
182 Operating Instructions, 05/2011, A5E01071724-03
Address Name Type Initial value Comment
48.0 CAM6WR_ERR BOOL FALSE 1 = error in "Write cam data 6" job
48.1 CAM7WR_ERR BOOL FALSE 1 = error in "Write cam data 7" job
48.2 CAM8WR_ERR BOOL FALSE 1 = error in "Write cam data 8" job
48.3 REFPT_ERR BOOL FALSE 1 = error in "Set reference point" job
48.4 AVAL_ERR BOOL FALSE 1 = error in "Set actual value" job
48.5 FVAL_ERR BOOL FALSE 1 = error in "Set actual value on-the-fly" job
48.6 ZOFF_ERR BOOL FALSE 1 = error in "Set zero offset" job
48.7 CH01CAM_ERR BOOL FALSE 1 = error in "Change 1 cam" job
49.0 CH16CAM_ERR BOOL FALSE 1 = error in "Change 16 cams" (fast cam
parameter change)
Error bits for read jobs
49.1 MDRD_ERR BOOL FALSE 1 = error in "Read machine data" job
49.2 CAM1RD_ERR BOOL FALSE 1 = error in "Read cam data 1" job
49.3 CAM2RD_ERR BOOL FALSE 1 = error in "Read cam data 2" job
49.4 CAM3RD_ERR BOOL FALSE 1 = error in "Read cam data 3" job
49.5 CAM4RD_ERR BOOL FALSE 1 = error in "Read cam data 4" job
49.6 CAM5RD_ERR BOOL FALSE 1 = error in "Read cam data 5" job
49.7 CAM6RD_ERR BOOL FALSE 1 = error in "Read cam data 6" job
50.0 CAM7RD_ERR BOOL FALSE 1 = error in "Read cam data 7" job
50.1 CAM8RD_ERR BOOL FALSE 1 = error in "Read cam data 8" job
50.2 MSRRD_ERR BOOL FALSE 1 = error in "Read measured values" job
50.3 CNTTRC_ERR BOOL FALSE 1 = error in "Read count values of counter
cam tracks" job
50.4 ACTPOS_ERR BOOL FALSE 1 = error in "Read position and track data" job
50.5 ENCVAL_ERR BOOL FALSE 1 = error in "Read current encoder value" job
50.6 CAMOUT_ERR BOOL FALSE 1 = error in "Read cam and track data" job
Job management for FB CAM_CTRL
52.0 JOB_ERR INT 0 Communication errors
54.0 JOBBUSY BOOL FALSE 1 = at least one job is running
54.1 JOBRESET BOOL FALSE 1 = reset all error and done bits
Data element for "Zero offset" job
86.0 ZOFF DINT L#0 Zero offset
Data element for "Set actual value" job
90.0 AVAL DINT L#0 Coordinate for "Set actual value"
Data element for "Set actual value on-the-fly" job
94.0 FVAL DINT L#0 Coordinate for "Set actual value on-the-fly"
Data element for "Set reference point" job
98.0 REFPT DINT L#0 Coordinate for "Set reference point"
To Next Page
Loading...
