Siemens S7-300 - Page 194

Data blocks / error lists
C.4 Error classes
FM 352 electronic cam controller
194 Operating Instructions, 05/2011, A5E01071724-03
No. Meaning Diagnostic
interrupt
Incorrect number of cams
144
Cause You have specified a value other than 0 to 3 for the number of
cams.
Yes
Incorrect hysteresis 145
Cause The hysteresis is outside the range 0 to 65535 * resolution.
The hysteresis is greater than [¼ x operating range] or {¼ x
rotary axis range].
Yes
Incorrect simulation velocity 146
Cause The simulation velocity is outside the range 1000*RES to
3*10
7
*RES, or is greater than 5* 10
8
µm/min.
The simulation velocity cannot be set internally.
Yes
Incorrect track 147
Cause Activation of a track outside 0 to 15 (bits 0 to 15) was selected.
Yes
Incorrect selection of enable inputs 148
Cause You wanted to enable a track outside 3 to 10 (bits 0 to 7) using
an external signal.
Yes
Incorrect selection of special tracks 149
Cause You wanted to define a track outside 0, 1 and 2 (bits 0, 1 and
2) as a special track
Yes
Incorrect high count value track 0 150
Cause You have specified a count value < 2 or > 65535 as the high
count value.
Yes
Incorrect high count value track 1 151
Cause You have specified a count value < 2 or > 65535 as the high
count value.
Yes
Incorrect resolution 200
Cause You have specified a resolution < 0.1 µm/pulse or
>1000 µm/pulse.
You have specified a distance/encoder revolution and a
number of pulses/encoder revolution, that results in a
resolution of < 0.1 or > 1000.
Yes
Position encoder does not match the operating range/rotary axis range 201
Cause SSI position encoder and rotary axis: The encoder does not
exactly cover the rotary axis range.
Linear axis: The encoder does not cover at least the operating
range (including software limit switches).
Yes