Siemens S7-300 - Page 62

Commissioning the FM 352
FM 352 electronic cam controller
62 Operating Instructions, 05/2011, A5E01071724-03
Hardware installation and wiring
In this first section, you install the FM 352 in your S7-300, and wire the front connector.
Step Description ✓
1 Installing the FM 352 (see chapter "Installing and removing the FM 352
(Page 27)")
Insert the module in an available slot. ❑
2 Wiring the FM 352 (see chapter "Wiring the FM 352 (Page 29)")
 Digital inputs at the front connector
 Digital outputs at the front connector
 Encoder connection
 Power supply to the FM 352
❑
❑
❑
❑
3 Check the limit switches relevant for safety
Check the function of the following:
 Limit switches
 Emergency stop equipment
❑
❑
4 Front connector
The front connector must be engaged. ❑
5 Check the shielding of the various cables. ❑
6 Switch on the power supply
Switch the CPU to STOP (safe state).
Switch off the 24 V supply to FM 352.
❑
❑
Setting up a project
You now create a project in STEP 7 .
The section below describes the steps when using SIMATIC Manager (without assistance
from the wizard).
Step Description ✓
1 If not already done, install the parameter assignment interface. ❑
2 Create a new project in SIMATIC Manager by selecting File > New. ❑
3 Add a station to your project (Insert > Station). ❑
4 Select the station, then run the configuration interface "HW Config" by
double-clicking "Hardware".
❑
5 In your hardware configuration, insert a rack containing the:
 Power supply module (PS)
 CPU/IM 153
 Function module (FM)
❑
❑
❑
6 Save this hardware configuration in HW Config (Station > Save). ❑