Digital electronic modules
3.17 2DO 24 VDC/2 A High Feature digital electronic module (6ES7132-4BB31-0AB0)
ET 200S
Manual, Edition 10/2005, A5E00514527-01
3-71
2DO 24 VDC/2 A High Feature Technical Specifications (6ES7132-4BB31-0AB0)
Dimensions and Weight
Dimensions W × H × D (mm)
(the total dimensions depend on the selected
terminal module)
15 × 81 × 52
Weight Approx. 40 g
Data for specific modules
Supports isochronous operation Yes
Number of outputs 2
Cable length
• Unshielded
max. 600 m
• Shielded
max. 1000 m
Parameter length 3 bytes
Voltages, currents, potentials
Rated load voltage L+ (from the power module) 24 VDC
• Polarity reversal
Yes
1
Total current of the outputs (per module) 4 A
Galvanic isolation
• Between the channels
no
• Between the channels and backplane bus
Yes
Permissible potential difference
• Between the different circuits
75 VDC / 60 VAC
Insulation tested 500 VDC
Current consumption
• From the rated load voltage L+ (no load)
max. 5 mA per channel
Power dissipation of the module Typically 1.4 W
Status, interrupts, diagnostics
Status display Green LED per channel
Diagnostics function
• General fault
Red "SF" LED
• Diagnostic functions readable
Yes
Data for selecting an actuator
Output voltage
• At signal "1"
min. L+ (-1 V)
Output current
• At signal "1"
– Rated value
– Permitted range
2 A
7 mA to 2.4 A
• With signal "0" (leakage current)
max. 0.5 mA
Output delay (for resistive load)
• at "0" to "1"
max. 100 µs
• At "1" to "0"
max. 400 µs
Load resistor range 12 Ω to 3.4 k Ω
To Next Page
Loading...
