Digital electronic modules
3.18 2DO 24 VAC to 230 VAC digital electronic module (6ES7132-4FB01-0AB0)
ET 200S
Manual, Edition 10/2005, A5E00514527-01
3-75
2DO 24 VAC to 230 VAC Technical Specifications (6ES7132-4FB01-0AB0)
Dimensions and Weight
Dimensions W × H × D (mm)
(the total dimensions depend on the selected
terminal module)
15 × 81 × 52
Weight Approx. 37 g
Data for specific modules
Supports isochronous operation no
Number of outputs 2
Cable length
• Unshielded
max. 600 m
• Shielded
max. 1000 m
Parameter length 3 bytes
Voltages, currents, potentials
Rated load voltage L1 (from the power module) 24 to 230 VAC
• Frequency
47 to 63 Hz
Total current of the outputs (per module)
• Up to 40° C
max. 2 A
1
• Up to 60° C
max. 1 A
1
Galvanic isolation
• Between the channels
no
• Between the channels and backplane bus
Yes
Insulation tested 2500 VDC
Current consumption
• From the backplane bus
max. 18 mA
• From rated load voltage L1 (no load)
max. 15 mA per channel
Power dissipation of the module max. 4 W
Status, interrupts, diagnostics
Status display Green LED per channel
Diagnostics function no
Data for selecting an actuator
Output voltage
• At signal "1"
min. L (-1.5 V)
Output current (per channel)
• At signal "1"
– Rated value
– Permitted range
2 A
0.1 mA to 2.2 A
• With signal "0" (leakage current)
max. 3 mA
Output delay (for resistive load)
• at "0" to "1"
max. 15 ms
• At "1" to "0"
max. 15 ms
Zero cross inhibit voltage max. 25 V
To Next Page
Loading...
