Analog electronic modules
4.22 2AO I High Feature analog electronic module (6ES7135-4MB02-0AB0)
ET 200S
Manual, Edition 10/2005, A5E00514527-01
4-109
Status, interrupts, diagnostics
Diagnostics function
• Group error display
Red "SF" LED
• Diagnostic information readable
Yes
Substitute values can be applied Yes, parameterizable
Analog value generation
Resolution (including sign) ± 20 mA/16 bits
4 to 20 mA/15 bits
Conversion time (per channel) max. 1.0 ms
Settling time
• For resistive load
0.25 ms
• For capacitive load
1.0 ms
• For inductive load
0.5 ms
Suppression of interference, limits of error
Crosstalk between the outputs > 60 dB
Operational limit (in the entire temperature
range, with reference to the output range)
±0.07 % (at 250 O load impedance)
±0.3 % (for all other load impedances)
Basic error limit (operational limit at 25 °C with
reference to output range)
±0.03 % (at 250 O load impedance)
±0.26 % (for all other load impedances)
Temperature error (with reference to the
output range)
± 0.001 %/K
Linearity error (with reference to the output
range)
± 0.02 %
Repeatability
(in steady state at 25 °C with reference to
output range)
± 0.01 %
Output ripple (with reference to output range,
bandwidth 0 to 50 kHz)
± 0.02 %
Data for selecting an actuator
Output range (rated value) ± 20 mA
4 to 20 mA
Load impedance (in the rated range of the
output)
• For current outputs
For inductive load
max. 500 Ω
1 mH
Current output
• Open circuit voltage
18 V
Destruction limit against voltages/currents
applied from outside
• Voltage at the outputs to M
ANA
15 V continuous; 75 V for max. 1 ms
(sampling ratio 1:20)
• Current
max. 50 mA DC
Connection of actuators
• Current output
Two-wire connection
supported
To Next Page
Loading...
