Siemens Simantic ET 200S - Page 7

Table of contents
ET 200S
Manual, Edition 10/2005, A5E00514527-01
vii
Table 4-12 SIMATIC S7 format: Measuring ranges Cu 10 Standard in °C and °F...................................... 4-8
Table 4-13 SIMATIC S7 format: Measuring ranges Cu 10 Climatic in °C and °F........................................ 4-9
Table 4-14 SIMATIC S7 format: Measuring range Type B in °C and °F...................................................... 4-9
Table 4-15 SIMATIC S7 format: Measuring range Type C in °C and °F ................................................... 4-10
Table 4-16 SIMATIC S7 format: Measuring range Type E in °C and °F.................................................... 4-10
Table 4-17 SIMATIC S7 format: Measuring range Type J in °C and °F .................................................... 4-11
Table 4-18 SIMATIC S7 format: Measuring range Type K in °C and °F.................................................... 4-11
Table 4-19 SIMATIC S7 format: Measuring range Type L in °C and °F.................................................... 4-11
Table 4-20 SIMATIC S7 format: Measuring range Type N in °C and °F ................................................... 4-12
Table 4-21 SIMATIC S7 format: Measuring range Type R, S in °C and °F............................................... 4-12
Table 4-22 SIMATIC S7 format: Measuring range Type T in °C and °F.................................................... 4-13
Table 4-23 SIMATIC S7 format: output range ± 5 V; ± 10 V; ± 20 mA...................................................... 4-13
Table 4-24 SIMATIC S7 format: Output ranges 1 V to 5 V; 4 mA to 20 mA.............................................. 4-14
Table 4-25 Compensation of the reference junction temperature ............................................................. 4-18
Table 4-26 Reference junction parameters................................................................................................ 4-21
Table 4-27 Dependence of the Input and Output Values on the Operating State of the PLC
(CPU of the DP Master) and the Power Supply Voltage L+ .................................................... 4-24
Table 4-28 Response of the Analog Modules, Depending on the Location of the Analog Input
Value in the Range of Values .................................................................................................. 4-25
Table 4-29 Response of the Analog Modules, Depending on the Location of the Analog Output
Value in the Range of Values .................................................................................................. 4-25
Table 4-30 Parameters for analog input modules U, I Standard ............................................................... 4-26
Table 4-31 Parameters for analog electronic modules U, I High Feature.................................................. 4-27
Table 4-32 Parameters for analog input modules U, I High Speed ........................................................... 4-28
Table 4-33 Parameters for analog input modules RTD, TC....................................................................... 4-29
Table 4-34 Parameters for 2AI RTD High Feature analog electroni
c module ........................................... 4-30
Table 4-35 Parameters for analog output modules U, I............................................................................. 4-33
Table 5-1 Parameters for the 4 IQ-SENSE................................................................................................ 5-2
Table 5-2 Diffuse sensor ............................................................................................................................ 5-5
Table 5-3 Retro-reflective sensor............................................................................................................... 5-5
Table 5-4 Standard feedback interface ...................................................................................................... 5-9
Table 5-5 Enhanced feedback interface .................................................................................................. 5-10
Table 5-6 Enhanced control interface ...................................................................................................... 5-11