Siemens SIMATIC IPC677E - Replacing the Processor

Maintaining and servicing your device
7.4 Removing and installing hardware
SIMATIC IPC677E
106 Operating Instructions, 04/2019, A5E45117996-AA
7.4.6 Replacing the processor
Requirement
● The device is disconnected from the mains and all connecting cables have been
removed.
● The device is open, see important information regarding this under Opening the Device
(Page 71).
● The memory modules have been removed.
● The air guide has been removed (see chapter "Replacing device fans (Page 92)").
● An original spare part, i.e. a processor of the same type.
Only an approved processor is permitted to be installed on the motherboard.
NOTICE
Damage to the processor
If the installed processor is operated with a higher clock frequency than permitted, it can be
destroyed or cause loss of data.
• Operate the processor only at a clock frequency that is equal to or less than the
permitted clock frequency.