Siemens SIMATIC PCS 7 - Stepcommand; Steptype; Subobjecttype

ID Description
4 Cyclically driven. Is not available in the batch dialog.
5 Event driven. Is not available in the batch dialog.
5.26 StepCommand
ID Description
6 Start
7 Stop
8 Abort
9 Hold (immediately)
10 Pause (after step)
11 Resume
12 Complete
12 Reset
14 Set breakpoint
15 Remove breakpoint
16 Resume breakpoint
32 Reset and start
5.27 StepType
ID Description
1 Equipment phase
2 Empty step
3 Operator instruction
6 Library reference
7 Transition
8 Container
10 Command step
11 Jump
5.28 SubObjectType
ID Description
1 OPD (operator dialog)
2 Active
4 Blocking
Description of the enumerations
5.26 StepCommand
SIMATIC BATCH - Views of the report data V9.0
Programming Manual, 05/2017, A5E38208785-AA 65